Skoda Octavia III 2013 Workshop Manual page 128

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Remove the camshaft housing
⇒ "2.6 Removing and installing camshaft housing",
page 114 .
– When installing again, mark the assignment of the roller rocker
arms and the hydraulic clearance compensation elements.
– Remove the roller rocker arms together with the hydraulic bal‐
ancing elements and lay aside on a clean surface.
– Put the piston of the relevant cylinder at "bottom dead centre".
Cylinders 1, 3, 4
– Position the guide plate -VAS 5161 A/31- onto the cylinder
head.
• Labelling -A- points to the turbocharger side
• Labelling - E - points to intake manifold side
– Tighten guide plate with knurled screws -VAS 5161/12- by
hand.
• Position of the knurled screws, as shown in the illustration
Cylinder 2
– Position the guide plate -VAS 5161 A/31- onto the cylinder
head.
• Labelling -A- points to the turbocharger side
• Labelling - E - points to intake manifold side
– Tighten guide plate with knurled screws -VAS 5161/12- by
hand.
• Position of the knurled screws, as shown in the illustration
Continued for all cylinders
– Screw the sealing bolt -VAS 5161/29-2- into the guide plate.
– Screw the adapter -VAS 5161/11- into the relevant pencil type
glow plug thread by hand.
120
Rep. gr.15 - Cylinder head, valve gear