Removing And Installing High Pressure Lines - Skoda Octavia III 2013 Workshop Manual

Octavia III 2013 ➤ , Octavia III 2014 ➤
1.6/66; 77; 81; 2.0/105; 110; 135 kW TDI CR engine - Edition 07.2014
– Replace the gasket ring for the injection channel, for this step
use the assembly sleeve - T10377- .
Continuation for used and new injection units:
– Coat all O-rings with assembly oil, engine oil or diesel fuel be‐
fore installation.
– Install the injection units.
– First tighten the union nuts of the high pressure lines hand-
tight. Check that seating is free of tension.
– After replacement of one or more injection units the correction
values for the new injection units must be written to the engine
control unit
⇒ "2.4 Adjust the correction values for injection units",
page 326 .
– Filling and bleeding the fuel system
⇒ "1.3 Filling/bleeding the fuel system", page 321
Tightening torque
♦ Summary of components - injection units (injectors)
⇒ "2.1 Summary of components - injection units (injectors)",
page 323 .
2.9 Removing and installing high pressure
lines
2.9.1 Remove high pressure line between fuel
distributor and the high pressure pump.
Removing
Note
Safety precautions when working on the fuel supply system
♦
⇒ "2 Safety instructions", page 3
Observe rules for cleanliness
♦
⇒ "3.1 Rules of cleanliness", page 6
– Remove engine cover
⇒ "1.1 Removing and installing engine trim panel", page 10
– Clean fuel line and line end with cold cleaner and blow dry with
compressed air.
334
Rep. gr.23 - Mixture preparation - injection
.
.
.
.