Table of Contents
Advertisement
QUICK START GUIDE
VISUAL DISPLAY
3.Use Button 3 to scroll to PIN followed by
Button 4 to enter the Enter PIN page.
4.Enter the Owner PIN (Default 1001) to
enter the PIN Menu page.
5.Use Button 3 to scroll to AdaptiCut™
followed by Button 4 to enter the AdaptiCut™
adjustment page.
6.Use Button 2 & 3 to select either Speed
Decrease or Speed Increase as necessary,
followed by Button 4 to select
7.Use Button 1 to 4 to adjust the parameters
as desired.
Note: that once the desired settings have
been adjusted the screen will auto-matically
save the settings and return to the previous
screen if no buttons are pressed for 3
seconds.
Speed Decrease
EDC Reduction [%]
5.0%
en-18
Decrease Time [Sec]
2.5 Sec
VEHICLE SPEED
Vehicle Speed
Transport
Mow
Creep
The vehicle forward and reverse
transmission speeds are factory set to the
defaults stated in this manual however can
be adjusted via the display as follows:
Press Button 4 twice to enter the
1.
Main Menu
2.
Use Button 3 to scroll to Settings
followed by Button 4 to enter the
Settings Menu
Use Button 3 to scroll to PIN
3.
followed by Button 4 to enter the
Enter PIN page
4.
Enter the Owner PIN (default 1001)
to enter the PIN Menu page
5.
Use Button 3 to scroll to Vehicle
Speed followed by Button 4 to enter
the Vehicle Speed settings screen
Use Button 2 & 3 to select the speed
6.
to be adjusted followed by Button 4
to select
7.
Use Button 2 & 3 to increase or
decrease as desired, followed by
Button 4 to save
8.
Adjust the other speeds as
necessary or use Button 1 to exit
FWD
25 km/h
REV
8 Mm/h
FWD
13 km/h
REV
6 Km/h
FWD
8 Km/h
REV
5 Km/h
Advertisement
Table of Contents
