Table of Contents
Advertisement
VISUAL DISPLAY
FLAIL \ CYLINDER MODE
Flail \ Cylinder Mode
Flail
Cylinder
The MT503 cutting system is capable of
providing power to both Magna 250 Cutting
cylinders and MT Series flail units. To ensure
that these run at their intended speed it is
important to ensure the machine's cutting
system is configured correctly.
The cutting system mode can be selected
via the display as follows:
Press Button 4 twice to enter the
1.
Main Menu
2.
Use Button 3 to scroll to Settings
followed by Button 4 to enter the
Settings Menu
3.
Use Button 3 to scroll to PIN fol-
lowed by Button 4 to enter the Enter
PIN page
4.
Enter the Owner PIN (default 1001)
to enter the PIN Menu page
5.
Use Button 3 to scroll to Flail \
Cylinder Mode followed by Button
4 to enter the Flail \ Cylinder Mode
settings screen
6.
Use Button 2 & 3 to select the
required mode as appropriate
followed by Button 4 to set
7.
Button 1 is then used to exit to the
Main Menu or Home Screen
QUICK START GUIDE
LIFT ON REVERSE
Lift On Reverse
Disabled
Enabled
The cutting units will automatically lift to the
Cross Cut position while mowing and the
vehicle is moved in reverse. Lift On Reverse
can be disabled via the display as follows:
1.
Press Button 4 twice to enter the
Main Menu
2.
Use Button 3 to scroll to Settings
followed by Button 4 to enter the
Settings Menu
Use Button 3 to scroll to PIN
3.
followed by Button 4 to enter the
Enter PIN page
4.
Enter the Owner PIN (default 1001)
to enter the PIN Menu page
Use Button 3 to scroll to Lift On
5.
Reverse followed by Button 4 to
enter the Lift On Reverse settings
screen
6.
Use Button 2 & 3 to select either
Enabled or Disabled as necessary,
followed by Button 4 to set Button 1
is then used to exit to the Main Menu
or Home Screen
en-19
Advertisement
Table of Contents
