Table of Contents
Advertisement
QUICK START GUIDE
VISUAL DISPLAY
INCLINOMETER
Inclinometer
Disabled
Enabled
Not Installed
Using the PIN Menu Buttons 2 and 3 to
arrow up and down, and Button 4 to select
Inclinometer and this gives you the option to
Enable or Disable TST™.
Note: If TST™ is installed, but disabled via
the screen, the machine angle when greater
than 14° will be displayed, however no
alarms or physical interventions will occur.
If TST™ is not installed then Not Installed
will be displayed on this screen and the
Disabled and Enabled options will be greyed
out.
!
CAUTION
While in Transport Mode the following
audible alarms are disabled for TST™
functions:
Maximum Slope Angle Exceeded, Inhibit
Cut and Stop Cut.
en-22
DISPLAY INCLINES
Display Inclines
0 º
Display Inclines
45 º
Only Visible if TST™ is installed and enabled
showing machine angle. Left/Right, Forward
Backwards. Rotating graphics to illustrate
direction. With a central value underneath
each picture to show magnitude of angle.
To access this screen go to Main Menu,
Service Menu, Display Inclines then
Button 4.
0 º
45 º
Advertisement
Table of Contents
