Table of Contents
Advertisement
QUICK START GUIDE
VISUAL DISPLAY
AUTO IDLE
1234
P
TM
MODE
The throttle drops to idle when the Forward/
Reverse pedal returns to neutral and the
vehicle speed is set to Transport (Cutter
Switch is off).
When this is active the Auto Idle icon will be
displayed on the screen.
CROSS CUT
Cross Cut
Disabled
Enabled
Cross Cut function raises the cutting unit to a
partially raised position, allowing the
operator to avoid obstructions without having
to fully lift the Cutter Deck. The Cutter PTO
will disengage within 3 seconds of reaching
en-20
123.4 Hours
A
Cross Cut position. If lowered again within 2
minutes the Cutter PTO will re-engage
automatically. After 2 minutes of continued
use in Cross Cut the PTO will have to be
manually reactivated using the PTO switch.
To activate Cross Cut, with the cutting unit in
lowered position move the Lift /Lower switch
momentarily to the rear in a quick motion. To
deactivate, move the switch lever fully
forward.
Using the PIN Menu Buttons 2 and 3 to
arrow up and down, Button 4 to select
Cross Cut, this gives you the option to
Enable or Disable
• Disabled - The unit will only lift while the
lift joystick is held
• Enabled - The unit will lift to a
predetermined height with a short single
activation of the lift joystick
WEIGHT TRANSFER / TRACTION BOOST
Traction Boost
Disabled
Momentary
Maintained
Using the PIN Menu Buttons 2 and 3 to
arrow up and down, and Button 4 to select
Traction Boost, this gives you three options
Disabled - Traction Boost is switched off.
• Momentary - Traction Boost is only
active while the Traction Boost button on
the armrest pod is pressed.
• Maintained - Traction Boost can be
turned on permanently by pressing the
Traction Boost button on the armrest pod.
Advertisement
Table of Contents
