Adjustments; Speed Limiter; Rear Wheel Toe-In; Alternator - Ransomes hr3806 Parts And Maintenance Manual

6

ADJUSTMENTS

ADJUSTMENTS
6.1

SPEED LIMITER

The transport and mow speeds are factory set and
should not need altering.
6.2

REAR WHEEL TOE-IN

The rear wheels should have 1/8" (3.2mm) toe-in
from the front of the wheel to the back of the wheel.
Adjust as follows:
1. Loosen locknuts N at balljoints near both rear
wheels.
2. Rotate the tie rod O until wheels are correctly
positioned. Adjust both tie rods an equal
amount.
3. Re-tighten locknuts. The tires should then be 1/
8" closer at the front than the rear.
6.3

ALTERNATOR

The fan belt is adjusted so that it can be deflected
5mm (0.2in) with a force of 5 kg (11 lbs) applied
midway between the crankshaft and alternator
pulley. (Fig.17) To adjust:
1. Loosen alternator bolts S & T.
2. Move the alternator to tighten or loosen fan
belt.
3. Tighten bolts S & T.
Check belt tension and condition of belt every 250
hours.
RANSOMES HR3806 Series: DZ
MAINTENANCE AND PARTS MANUAL
NOTE: Textron Turf Care cannot be held responsible
for loss of performance or machine damage if these
speeds are adjusted outside the speeds shown in the
machine specification.
Fig.16
Fig.17
GB-19