IBM eServer xSeries 445 Type 8870 Option Installation Manual page 48

Installing the SMP Expansion Module and cover
After installing options in the SMP Expansion Module, you will need to reinstall the
SMP Expansion Module cover and reinstall the SMP Expansion Module in the
server.
Complete the following steps to install the SMP Expansion Module cover and the
SMP Expansion Module:
1. Install the cover on the SMP Expansion Module:
CAM opening
Figure 34. Installing the SMP Expansion Module cover
36
xSeries 445 Type 8870: Option Installation Guide
a. Set the cover on top of the expansion module.
b. Extend the locking levers as shown in the illustration; then, let the cam on
the front of the cover fall into the cam opening on the SMP Expansion
Module circuit board.
Locking levers
c. Release the locking levers and align the rear of the cover with the rear edge
of the circuit board.
d. Press down on the cover until it snaps into place.
e. Lift slightly on the locking levers and rotate them back until they stop.