IBM eServer xSeries 445 Type 8870 Option Installation Manual page 49

Locking
levers
Figure 35. Locking lever position for installing the SMP Expansion Module
2. Install the SMP Expansion Module in the server:
Figure 36. Installing the SMP Expansion Module
a. Lift the SMP Expansion Module by its handle and use the finger relief to
hold the SMP Expansion Module steady.
b. Being careful not to damage the components on the center plane, lower the
SMP Expansion Module into the server.
c. Release the handle and slide the SMP Expansion Module toward the center
plane until it stops.
d. Rotate the SMP Expansion Module locking levers forward until the SMP
Expansion Module is securely fastened in place. See the following
illustration.
Handle
Locking
levers
Center plane
Handle
Chapter 2. Installing options
37