Removing And Replacing The Bezel Assembly - IBM LS20 - BladeCenter - 8850 Service Manual

Removing and replacing the bezel assembly

To remove the bezel assembly, complete the following steps.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Open the blade server cover (see "Operating the blade server cover" on page
3. Press the bezel-assembly release on each side of the blade server and pull the
4. Disconnect the control-panel cable from the control-panel connector.
5. Pull the bezel assembly away from the blade server.
6. Store the bezel assembly in a safe place.
To install the bezel assembly, complete the following steps.
1. Read the safety information that begins on page v and "Installation guidelines"
2. Connect the control-panel cable to the control-panel connector on the system
3. Carefully slide the bezel assembly onto the blade server until it clicks into place.
66
AMD Opteron LS20 Type 8850 for IBM BladeCenter: Problem Determination and Service Guide
Bezel-assembly
release
Control-panel
connector
Control-panel
cable
on page 59.
64 for instructions).
bezel assembly away from the blade server approximately 1.2 cm (0.5 inch).
Bezel-assembly
release
Control-panel
connector
Control-panel
cable
on page 59.
board.
Bezel-assembly
release
Bezel
assembly
Bezel-assembly
release
Bezel
assembly