IBM eServer xSeries 445 Type 8870 Option Installation Manual page 50

Figure 37. Locking lever position when the SMP Expansion Module is installed
3. Install the EMC shield on the rear of the server; then, hand tighten the blue
Figure 38. EMC shields
4. If you have other options to install or remove, do so now.
5. Close the top cover.
6. Slide the server into the rack enclosure until it stops; then, secure the server in
7. Connect all external cables.
8. Turn on the server.
38
xSeries 445 Type 8870: Option Installation Guide
Center plane
Locking
levers
Handle
e. Install the retention bracket.
Notes:
1) If there are two SMP Expansion Modules installed in your server, you
must install the retention bracket for each of the SMP Expansion
Modules. Be sure to install the bottom retention bracket first, then repeat
steps 2a through 2e for the top SMP Expansion Module.
2) If you are going to ship or move the server over a long distance, you
must reinstall the shipping thumbscrews.
thumbscrews to secure the EMC shield.
EMC shields
Thumbscrews
For use with one
SMP Module
the rack enclosure using the quick release latches.
Cover
Thumbscrews
For use with two
SMP Modules