Figure 29. Removing the EMC shield
7. Grasp each of the locking levers on the top of the SMP Expansion Module, and
8. Working from the right side of the server, rotate the two locking levers toward
Latch
Figure 30. Rotate the locking levers to remove the SMP Expansion Module
9. Use the handle and the finger relief on the SMP Expansion Module cover to
10. Remove the SMP Expansion Module cover:
34
xSeries 445 Type 8870: Option Installation Guide
lift them up slightly.
you until they are fully extended, as shown.
Attention:
When removing the SMP Expansion Module from the server, lift it
out carefully, taking care not to damage the components on the center plane.
carefully lift the SMP Expansion Module out of the server.
a. Place the SMP Expansion Module on a flat, level surface.
b. Rotate the two locking levers until they are fully extended beyond the edge
of the SMP Expansion Module cover. Do not force the locking levers past
the position shown in the illustration.
SMP Expansion
Cables
EMC Shield
SMP baffle
Locking
levers
Finger relief
Handle