Turning Off The Server - IBM eServer xSeries 445 Type 8870 Option Installation Manual

Turning off the server

When you turn off the server and leave it connected to ac power, the server can
respond to requests from the service processor, such as a remote request to turn
on the server. To remove all power from the server, you must disconnect it from the
power source.
Some operating systems require an orderly shutdown before you turn off the server.
See your operating-system documentation for information about shutting down the
operating system.
Statement 5:
CAUTION:
The power control button on the device and the power switch on the power
supply do not turn off the electrical current supplied to the device. The device
also might have more than one power cord. To remove all electrical current
from the device, ensure that all power cords are disconnected from the power
source.
You can turn off the server in any of the following ways:
v You can turn off the server from the operating system, if your operating system
v You can press the power-control button to start an orderly shutdown of the
v If the operating system stops functioning, you can press and hold the
v If the server is connected to an Advanced System Management interconnect
v The server can be turned off from the Remote Supervisor Adapter user interface.
v If the Wake on LAN feature turned on the server, the Wake on LAN feature can
v The Remote Supervisor Adapter can turn off the server as an automatic
Note: When you press the power-control button on either the primary or secondary
14
xSeries 445 Type 8870: Option Installation Guide
supports this feature. After an orderly shutdown of the operating system, the
server will be turned off automatically.
operating system and turn off the server, if your operating system supports this
feature.
power-control button until the server turns off.
network that contains at least one server with an optional Remote Supervisor
Adapter installed, the server can be turned off from the Remote Supervisor
Adapter user interface.
turn off the server.
response to a critical system failure.
server in a 16-way configuration, both servers will be turned off. If both
servers do not turn off when either power-control button is pressed, see the
Hardware Maintenance Manual and Troubleshooting Guide on the IBM
xSeries Documentation CD.