Mercedes-Benz EQE 350+ Owner's Manual page 71

Occupant safety
68 68
& W W ARNING
ARNING Risk of injury or death if the
permissible gross mass of the child and
child restraint system together is excee-
ded.
Too much load may be placed on the ISOFIX
or i‑Size child restraint systems and the child
may not be restrained correctly in the event of
an accident, for example.
If the child and the child restraint system
#
together weigh more than 33 kg, only
use an ISOFIX or i‑Size child restraint
system with which the child is secured
with the vehicle seat belt.
Also secure the child restraint system
#
with the Top Tether belt, if available.
Always comply with the information about the
mass of the child restraint system:
in the manufacturer's installation and operat-
R
ing instructions for the child restraint system
used
on a label on the child restraint system, if
R
present
Regularly check that the permissible gross mass
of the child and child restraint system is still com-
plied with.
When tting a child restraint system, observe the
following:
O Always observe the correct use of the seats
and consider their suitability for attaching a
child restraint system.
ISOFIX child seat anchor (
/
or
i‑Size child seat anchor (
/
O Always comply with the manufacturer's
installation and operating instructions for the
child restraint system used.
O Make sure that the child's feet do not touch
the front seat. If necessary, move the front
seat slightly forwards.
® When tting an ISOFIX child restraint sys-
tem, also observe the following:
O When using a bab When using a baby car seat in w y car seat in weight gr
0/0+ and a r 0/0+ and a rearw earwar ard-f d-facing c acing child r
system in w syst em in weight gr eight group 1 on a r oup 1 on a rear seat
adjust the front seat so that the seat does
not touch the child restraint system.
O When using a f When using a forw
syst system in w em in weight gr
restraint from the respective seat, if possible.
In addition, the backrest of the child restraint
system must lie as at as possible against
the backrest of the vehicle seat.
A er the child restraint system has been
page 66)
removed, replace the head restraint immedi-
ately and adjust all head restraints correctly.
page 67)
O If the head restraint of the child seat cannot
be fully extended when it is installed in the
vehicle, this will result in restrictions on the
maximum size setting for child restraint sys-
tems in weight group 2 or 3.
Contact with the roof when the head
restraint is fully extended and locked in place
will not result in any restrictions on use.
O The child restraint system must not be put
under strain between the roof and the seat
eight group oup
cushion and/or be tted facing the wrong
hild res estr traint aint
direction. Where possible, adjust the seat
ear seat: :
cushion inclination accordingly.
orwar ard-f d-facing c acing child r hild res estr traint aint
eight group 1: oup 1: remove the head