Mercedes-Benz EQE 350+ Owner's Manual page 397

Table of Contents

Advertisement

394 Breakdown assistance
394
* N N O O TE TE Damage to the vehicle due to incor-
rect use of the towing eye or trailer hitch
When a towing eye or trailer hitch is used to
recover a vehicle, the vehicle may be damaged
in the process.
Only use the towing eye or trailer hitch to
#
tow away or tow start the vehicle.
Do not use the towing eye or trailer hitch
#
to tow the vehicle during recovery.
T T o o w w -st -star arting t
ting the v
he vehicle
ehicle
If the drive system does not start, have the
#
vehicle transported to a quali ed specialist
workshop, e.g. a Mercedes-Benz Service
Centre.
The drive system cannot be started by tow-
#
starting the vehicle. Do not perform any
attempts to tow-start the vehicle.
Electrical fuses
Electr
ical fuses
N N o o t t es on electr
es on electrical fuses
ical fuses
& W W ARNING
ARNING Risk of accident and injury due
to overloaded lines
If you manipulate or bridge a faulty fuse or if
you replace it with a fuse with a higher amper-
age, the electric line could be overloaded.
This could result in a re.
Always replace faulty fuses with speci-
#
ed new fuses containing the correct
amperage.
* N N O O TE TE Damage due to incorrect fuses
Using incorrect fuses can result in damage to
electrical components or systems or their
functions being considerably restricted.
Use only fuses approved for Mercedes-
#
Benz with the respective speci ed fuse
rating.
Blown fuses must be replaced with fuses of the
same rating, which you can recognise by the col-
our and the label. The fuse ratings and further
information to be observed can be found in the
fuse assignment diagram.
F F use assignment diagr
use assignment diagram:
am: on the fuse box in the
rear passenger compartment (
/
* NO
NOTE TE Damage or malfunctions caused by
moisture
Moisture may cause damage to the electrical
system or cause it to malfunction.
When the fuse box is open, make sure
#
that no moisture can enter the fuse box.
When closing the fuse box, make sure
#
that the seal of the lid is positioned cor-
rectly on the fuse box.
If the newly inserted fuse also blows, have the
cause traced and recti ed at a quali ed specialist
workshop.
Ensure the following before replacing a fuse:
The vehicle is secured against rolling away.
R
All electrical consumers are switched o .
R
The vehicle is switched o .
R
page 395).

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents