Mercedes-Benz EQE 350+ Owner's Manual page 195

192 Driving and parking
192
Engaging neutr Eng aging neutral N al N
Depress the brake pedal and push the DIRECT
#
SELECT lever up or down to the rst point of
resistance, holding it there until the transmis-
sion position i is shown on the driver's dis-
play.
Subsequently releasing the brake pedal will allow
you to move the vehicle freely, e.g. to push it or
tow it away.
If you w If y ou want t ant the tr he transmission t ansmission to r o remain in neutr
N ev N even if t en if the v he vehicle is switc ehicle is switched hed o :
Start the vehicle.
#
Depress the brake pedal and engage neutral
#
i.
Release the brake pedal.
#
Switch o the vehicle.
#
% If you then exit the vehicle leaving the key in
the vehicle, the transmission will remain in
neutral i.
Eng Engaging par aging park position P k position P
Observe the notes on parking the vehicle
#
( page 212).
/
Depress the brake pedal until the vehicle
#
comes to a standstill.
When the vehicle is at a standstill, press but-
#
ton j.
Park position is only engaged when the trans-
mission position display j is shown in the
driver's display. If no transmission position dis-
play j appears, secure the vehicle to prevent
it from rolling away.
Park position j is engaged automatically if one
emain in neutral al
of the following conditions is met:
o :
You switch the vehicle o in transmission posi-
R
tion h or k.
You open the driver's door when the vehicle is
R
at a standstill or when driving at a very low
speed and the transmission is in position h
or k.
%
To manoeuvre with an open driver's door,
open the driver's door while at a standstill and
engage transmission position h or k again.
% If you have engaged park position j or
switched o the vehicle and no transmission
position display is displayed, secure the vehi-
cle from rolling away ( page 215).
/
Eng Engaging dr aging driv ive position D e position D
Depress the brake pedal and push the DIRECT
#
SELECT lever down past the rst point of
resistance.
F F unction of t unction of the 4MA he 4MATIC TIC
The exible all-wheel distribution of the 4MATIC
means the drive is always ideally distributed
between both axles. Depending on the situation,
only the front axle or only the rear axle can be
driven, or the drive can be distributed continu-
ously between both axles.
This means that recuperation can be used even
more e ectively and the range of the vehicle can
be increased ( page 184).
/
®
Together with ESP and 4ETS, 4MATIC improves
the traction of your vehicle whenever a driven
wheel spins due to insu cient traction.
If you fail to adapt your driving style, 4MATIC can
neither reduce the risk of an accident nor override
the laws of physics. It cannot take into account