Mercedes-Benz EQE 350+ Owner's Manual page 201

198 Driving and parking
198
Perform a visual check of the charg-
R
ing station for obvious faults, such as
massive damage to the housing or
charging cable.
For charging stations without a preinstal-
#
led charging cable:
For safety reasons, only use charging
R
cables that have been tested and
approved by the manufacturer for
charging the high-voltage battery in
an electric vehicle.
Never use damaged charging cables.
R
Do not extend the charging cable.
R
Do not use adapters.
R
Make sure to observe the safety informa-
#
tion on the charging station.
& D D AN
ANGER GER Risk of fatal injuries when carry-
ing out maintenance work during the
charging process
During the charging process, the high-voltage
on-board electrical system is under high volt-
age.
Do not perform any maintenance work
#
during the charging process.
Most charging stations must be activated before
the charging process, e.g. using an RFID card or
via Plug & Charge. Observe the on-site operator's
instructions for the charging station and the notes
on Mercedes me Charge (see the vehicle's Digital
Owner's Manual).
The charging cable for the vehicle must not be
longer than 30 m due to the legal requirements in
some countries. This is to prevent the interfer-
ence of signals being received by radio communi-
cation devices in the vehicle or in close proximity
to the charging station. Be aware that parts of the
charging cable may be routed underground. If in
doubt, ask the charging station operator if this is
the case before charging the high-voltage battery.
The amount of energy dispensed for the charging
process, shown by the charging station, may be
higher than the amount of energy actually absor-
bed by the high-voltage battery. This is the result
of di erent levels of charging losses and is descri-
bed as recharge e ciency. Charging losses occur,
for example, due to heat that builds up when
charging or from auxiliary consumers that are
switched on. Further information on recharge e -
ciency can be obtained at a quali ed specialist
workshop.
Se Setting t tting the maximum per he maximum permissible c missible char
r r ent f ent for c or char harging at a mains socket ging at a mains socket
* N N O O TE TE Overloading the mains socket due
to excessive charging current
If the charging current is too high, the fuse
could be tripped or the external mains supply
could overheat.
Ensure that the external mains supply
#
has been designed to handle the charg-
ing current provided.
For safety reasons, only use the charging
#
cable supplied with the vehicle or an
original Mercedes-Benz charging cable.
Mercedes-Benz thoroughly tests these
original charging cables for their suitabil-
ity for high-voltage charging of your vehi-
cle. Purchase these parts at a Mercedes-
harging cur- ging cur-