Color Is Uneven Or Color Is Wrong - Xerox WorkCentre C2424DX Service Manual

Color is Uneven or Color is Wrong

Step Questions and Actions
To remove discolored jets in the printhead,
1
1.
run the solid fill test print for the color
displaying the discolored jets.
NOTE: For instructions on printing solid fill test
prints, see "13-19: Black, Red, Green,
Blue, Cyan, Magenta, and Yellow Solid
Fills" on page 5-42.
Purge the printhead up to three times. If
1.
some improvement is seen, the ink could be
discolored due to a long period of time
without use.
Did this correct the problem?
2.
Clean the maintenance kit wiper blade or
2
1.
replace the maintenance kit.
Did this correct the problem?
2.
Check the thermal regulation of the drum.
3 1.
Run the service diagnostics drum thermal
2.
check test, see "Check Heaters Menu" on
page 4-25.
Are the drum thermal values out of the
3.
appropriate range?
Ensure the drum fan is correctly installed
4
1.
and operates correctly.
Verify the drum temperature sensor is in
5 1.
contact with the drum.
Clean or replace the drum termperature
2.
sensor.
Did this correct the problem?
3.
5-16
This may be due to incorrect colors in the ink loader, old
ink in the printhead, color mixing at the faceplate, or
drum thermal problems.
NOTE:
Using non-Xerox ink may cause unpredictable color
results.
s2424-078
Yes
Complete.
Complete.
Go to Step 4.
Go to Step 5.
Complete.
WorkCentre C2424 Service Manual
No
Go to Step 2
Go to Step 3.
Go to Step 5.
Replace the
drum fan.
Replace in the
following order:
Drum heater
relay board
Drum
assembly
Electronics
module