33,0XX.xx Errors - Tray Manager Device Faults
33,001.42:
Tray 1 width value too low.
33,002.43:
Tray 1 width value too high.
Troubleshooting Procedure
Step
Questions and Actions
Check the wiring and connectors from the
1
1.
front door to the I/O board.
Are the wires connected properly?
2.
Run the Test Tray 1 Width Sensor test.
2
1.
Did the test pass?
2.
34,0XX.xx Errors - Printhead NVRAM Faults
34,001.43:
An error occurred while attempting read/write access to the printhead
calibration partition in NVRAM. The printhead cable may be unplugged.
34,002.44:
An error occurred while attempting read/write access to the printhead ink
data partition in NVRAM.
34,003.45:
An error occurred while attempting read/write access to the printhead
data partition in NVRAM.
34,004.46:
An error occurred while accessing the printhead NVRAM hardware for
the purpose of initialization. The printhead cable may be unplugged.
Troubleshooting Procedure
Step
Questions and Actions
Check and reseat all wiring to the printhead.
1
1.
Did this correct the problem?
2.
Error Messages and Codes
Yes
Go to Step 2.
Replace the
wiring harness.
Replace the I/O
Replace the
board.
front door.
Yes
Complete.
Replace in the
following order:
Printhead
Electronics
Module.
No
No
3-35