Oil Streaks on Print
Step
Questions and Actions
There may be too much oil on the drum.
1
1.
Inspect and clean the maintenance kit wiper
2.
blade.
If necessary, replace the maintenance kit.
3.
Did this correct the problem?
4.
Ensure ground integrity for the drum
2
1.
maintenance unit is intact.
Check the back of the drum maintenance
2.
unit to drum maintenance shaft to drum fan
ground clip.
Did this correct the problem?
3.
Run pages through the printer to clean the
3
1.
drum by using the
routine from the system's control panel.
Did this correct the problem?
2.
Clean the paper release blade and the exit
4
1.
guides.
Did this correct the problem?
2.
Use service diagnostics to verify the drum
5
1.
maintenance cam roller and pivot plate are
operating correctly.
Did this correct the problem?
2.
5-28
Oil stains the edge of the print.
s2424-085
Remove Print Smears
Yes
Complete.
Complete.
Complete.
Complete.
Complete.
WorkCentre C2424 Service Manual
No
Go to Step 2.
Go to Step 3.
Go to Step 4.
Go to Step 5.
Replace the
pivot plate or
drum
maintenance
cam roller if
damaged.