General Safety - Xerox WorkCentre C2424DX Service Manual

General Safety

The system and recommended supplies have been designed and tested to meet strict safety
requirements. Attention to the following information will ensure the continued safe operation
of the system.
Electrical Safety
Use the power cord supplied with the system.
Plug the power cord directly into a properly grounded electrical outlet.
Do not use a ground adapter plug to connect the system to an electrical outlet that does not
have a ground connection terminal.
Do not use an extension cord or power strip.
Warning
Avoid the potential of electrical shock by ensuring that the system is properly grounded.
Electrical products may be hazardous if misused.
Do not place the system in an area where people might step on the power cord.
Do not place objects on the power cord.
Do not block the ventilation openings. These openings are provided to prevent overheating
of the system.
Do not drop paper clips or staples into the system.
The power cord is attached to the system as a plug-in device on the side of the system. If it is
necessary to disconnect all electrical power from the system, disconnect the power cord from
the electrical outlet.
Warning
Do not remove the covers or guards that are fastened with screws unless you are installing
optional equipment and are specifically instructed to do so. Power should be OFF when
performing these installations. Disconnect the power cord when removing covers and
guards for installing optional equipment. Except for user-installable options, there are no
parts that you can maintain or service behind these covers.
Warning
The following are hazards to your safety:
The power cord is damaged or frayed.
Liquid is spilled into the system.
The system is exposed to water.
If any of these conditions occur:
1.
Turn off the system immediately.
2. Disconnect the power cord from the electrical outlet.
3.
Call an authorized service representative.
Service Manual iii