Table of Contents
Advertisement
Jam Code Troubleshooting Procedures
Tray 4 media size sensor unexpectedly activated while transfixing the print.
Y2T
Tray 4 media size sensor unexpectedly activated while the system drum
Y2V
maintenance cycle was being performed.
Tray 4 media size sensor unexpectedly activated while system imaging.
Y2W
Tray 4 media size sensor unexpectedly activated while exiting print.
Y2X
Ensure ground integrity of the system (see page 4-73).
1.
Ensure the paper guides are correctly set.
2.
Run the Monitor Sensors test to test the media size sensor.
3.
Replace the Tray 4 525-Sheet Feeder.
4.
Replace the pivot arm.
5.
Tray 4 pick flag triggered unexpectedly during abnormal shutdown.
Z2A
Tray 4 pick flag triggered unexpectedly during normal shutdown.
Z2B
Tray 4 Pick flag triggered unexpectedly during mechanical recovery.
Z2C
Tray 4 pick flag triggered unexpectedly during warm-up.
Z2D
Tray 4 pick flag triggered unexpectedly while system ready.
Z2E
Tray 4 pick flag triggered unexpectedly while system in fault state.
Z2F
Tray 4 pick flag triggered unexpectedly while system in standby.
Z2L
Tray 4 pick flag triggered unexpectedly while pick from Tray 2.
Z2M
Tray 4 pick flag triggered unexpectedly while pick from Tray 4.
Z2N
Tray 4 pick flag triggered unexpectedly while pick from Tray 4.
Z2P
Tray 4 pick flag triggered unexpectedly while pick from Tray 1.
Z2Q
Z2x (continued)
Tray 4 pick flag triggered unexpectedly while duplexing.
Z2R
Tray 4 pick flag triggered unexpectedly while paper staged for print.
Z2S
Tray 4 pick flag triggered unexpectedly while transfixing the print.
Z2T
Tray 4 pick flag triggered unexpectedly while the system drum maintenance cycle
Z2V
was being performed.
Tray 4 pick flag triggered unexpectedly during system imaging.
Z2W
Error Messages and Codes
(Continued)
3-65
Advertisement
Table of Contents
Troubleshooting
