Hayes Keyboard Dialing Feature Operation - Northern Telecom Meridian M3000 Reference Manual

Table 9-4xxx
Hayes keyboard dialing commands
Heading
&D0
&D1
&D2
&D3
&Q0
&Q5
&R0
&R1
&S0
&S1
Z0
Z1
&F
&Y0
&Y1

Hayes keyboard dialing feature operation

Procedures 9-15 through 9-19 present dialing procedures for Hayes
Keyboard Dialing (KBD) operation.
Note: (CR) indicates a carriage return in the following procedures.
Use Procedure 9-15 to establish a Hayes KBD data call.
Meridian 1 Options 201, 211 Meridian SL-100 M3000 Touchphone Reference Manual MSL03
(continued)
Heading
Ignore DTR. This command is the default if ASSERTDTR DPOPT is
datafilled for TADO.
Assume command state when the on-to-off transition of DTR occurs.
Go on-hook when the on-to-off transition of DTR occurs. This command
is the default if ASSERTDTR DPOPT is not datafilled for TADO.
Go on-hook and reset to default settings (i.e. TADO profile
configuration).
TADO ignores S37; connection is attempted at the speed of the last
autobaud command.
TADO attempts to connect at baud rate selected by S37.
CTS, CD, and DSR track far-end RTS. This command is the default if
ASSERTRTS DPOPT is not datafilled for TADO.
Assume CTS is always present. This command asserts the EIA control
leads CTS, CD, and DSR. This command is the default if ASSERTRTS
DPOPT is datafilled for TADO.
Assume DSR is present. This command asserts the EIA control leads
CTS, CD, and DSR. This command is the default if ASSERTRTS
DPOPT is datafilled for TADO.
CTS, CD, and DSR track far-end RTS. This command is the default if
ASSERTRTS DPOPT is not datafilled for TADO.
Reset TADO to default settings.
Reset TADO to default settings.
Reset TADO to default settings.
Reset TADO to default settings.
Reset TADO to default settings.
Keyboard dialing 9-17
-end-