Cleaning; Operating; Automatic Set Relocation (Asr) - Northern Telecom Meridian M3000 Reference Manual

Cleaning

The touch-sensitive screen of the M3000 Touchphone can be damaged by
some cleaning agents. Only use the materials specified in this publication.
Prior to cleaning the screen, disable the touch-functions of the display screen
to prevent accidental activation or erasure of directory entries. To clean the
M3000 Touchphone, do the following:
•
•
•
•

Operating

Do not place the M3000 Touchphone in a position where it is exposed to
direct, unfiltered sunlight for prolonged periods of time to prevent damage
to the LCD beneath the touch surface.
Only use fingers to operate the touch positions on the M3000 Touchphone
display screen. Do not use a pencil or ball-point pen because sharp, hard
objects may scratch or otherwise damage the touch surface.

Automatic Set Relocation (ASR)

Automatic Set Relocation (ASR) allows a telephone user to move IVD
telephone sets from one location to another without the intervention of
service personnel. The ASR process involves two steps.
The first step is the ASR out process. This step requires the user to enter
special codes and unplug the telephone set. Entering these codes causes the
switch to perform the equivalent of a CKLN SERVORD command on the
set. All directory numbers and features associated with the set are
transferred from the old LEN to a virtual LEN (a temporary LEN). All
Meridian 1 Options 201, 211 Meridian SL-100 M3000 Touchphone Reference Manual MSL03
WARNING
Shock hazard and equipment damage
Never spray any kind of cleaning solvent directly on the
screen or any other part of the telephone.
From IDLE or ACTIVE state screens, touch TOUCH PROFILE.
From the TOUCH PROFILE screen, activate the CLEAN SCREEN
position (right bottom corner of screen). This disables all the touch
screen functions.
Wipe the display screen clean using only a new, fresh TEXWIPE Optic
Pad #TX-811. Other areas of the M3000 Touchphone can be cleaned
with the same material after the screen has been cleaned.
After cleaning the M3000 Touchphone, enable the touch functions by
lifting the handset from its cradle and placing it back in its cradle. This
returns the screen to the state accessed from the TOUCH PROFILE
screen.
Testing and maintenance 8-7