Programming Instructions; Parameter Instructions; Param_Rf600 - Siemens SIMATIC Ident Function Manual

4.5

Programming instructions

4.5.1

Parameter instructions

The configuration data is sent to the Ident system using the "Param_RF600",
"Param_RF18xC" or "Param_RFID181EIP" instruction. In addition to this, the instruction
resets the required start values of the "HW_CONNECT" variables for the reader channels
(read points). Note that this instruction always needs to be executed first before other
instructions can be executed. The instruction must be executed each time the controller
or module is restarted.
4.5.1.1

Param_RF600

You can use the "Param_RF600" instruction to transfer the configuration data to an
RF600 reader.
Figure 4-2
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
"Param_RF600" instruction
Configuring the instructions
4.5 Programming instructions
29