Siemens SIMATIC Ident Function Manual page 111
Hide thumbs
Also See for SIMATIC Ident:
- System manual (362 pages) ,
- Function manual (142 pages) ,
- Operating manual (80 pages)
Table of Contents
Advertisement
Error mes-
Description
sage
(hex)
0xE6FE8700
Read access to the transponder has failed.
0xE6FE8800
Write access to the transponder has failed.
0xE6FE8900
Writing the EPC ID/UID on the transponder has failed.
0xE6FE8A00
Enabling write protection on the transponder has failed.
0xE6FE8B00
The "Kill" command failed.
0xE7FE0100
In this state, only the "Reset_*" command ("WRITE-CONFIG" with "CMDSEL =0" and "CMD = 0x78")
is permitted.
0xE7FE0200
The command code "CMD" or the value in "CMDSEL" is not permitted.
Possible cause / action to be taken:
•
The "CMDSEL" or "CMDDIM" parameter was set incorrectly. Check the parameters.
•
The value of the parameter "CMDSEL" must be between 0 and 9 and may never be higher than the
value of the "CMDDIM" parameter (max. 10).
0xE7FE0300
The value of the "LEN_DATA" parameter of the command is too long and does not match the global
data reserved within the send data buffer (TXBUF).
0xE7FE0400
The receive data buffer (RXBUF) or the send data buffer (TXBUF) is too small, the buffer created at
TXBUF/RXBUF does not have the correct data type or the parameter "LEN_DATA" has a negative
value.
Possible cause / action to be taken:
•
Check whether the buffers TXBUF/RXBUF are at least as large as specified in "LEN_DATA".
0xE7FE0500
Only an "INIT" command is permitted as the next command. All other commands are rejected.
0xE7FE0600
Wrong data record index of an acyclic data record
Permitted index is in the ranges "101 ... 108" and "-20401 ... -20418".
0xE7FE0700
The reader or communication module does not respond to "INIT" ("INIT_ACTIVE" is expected in the
cyclic status message).
The next steps:
•
Check the address parameter "LADDR".
0xE7FE0800
Timeout during "INIT" (60 seconds)
0xE7FE0900
Command repetition is not supported.
0xE7FE0A00
Error during the transfer of the PDU (Protocol Data Unit).
0xFxFExx00
An "FxFExxxx" error is identical to the corresponding "ExFExxxx" error (see "ExFExxxx" error).
Byte 3 contains additional warning information.
Ident profile, Add-on instruction for Rockwell systems
Function Manual, 07/2020, C79000-G8976-C410-04
5.1 Error messages from the Ident profile / Ident instructions
Diagnostics and error messages
111
Advertisement
Table of Contents
