Programming Via Simatic Controller; Digital Inputs/Outputs - Siemens SIMATIC RF186C Operating Instructions Manual

Programming via SIMATIC controller

This section is intended only for S7 users.
You can program and configure the SIMATIC RF185C, RF186C, RF188C as well as the
RF186CI and RF188CI communication modules using Ident instructions via a SIMATIC
controller.
To configure Ident systems using STEP 7 Basic / Professional (TIA Portal), you need
appropriate Ident instructions. The Ident library with the Ident profile and the Ident blocks are
integrated in STEP 7 as of version V15.1.
You can find a detailed description of the Ident profile and the Ident blocks in the "Ident
profile and Ident blocks (https://support.industry.siemens.com/cs/ww/en/ps/14970/man)"
function manual.
8.1

Digital inputs/outputs

The RF18xCI communication modules have configurable digital inputs/outputs that you can
configure using the WBM. You will find more information on this in the section "The "Settings
- Digital outputs" menu item (Page 71)".
You can operate the interface as a single input or a single output, as needed, or you can
connect an IO-Link module. IO-Link modules with up to 8 inputs and/or 8 outputs are
supported.
The inputs/outputs are mapped in a data word each in the process image of the controller.
Because the physical output value of the CM can deviate from the process image value of
the controller through internal linking, each physical output value is also mapped as
additional input in the controller.
Table 8- 1
Byte 1
Bit
Input
Output
Byte 0
Bit
Input
Output
PI: Physical output value
DI: Digital input value
DO: Digital output value
SIMATIC RF185C, RF186C, RF188C, RF186CI, RF188CI
Operating Instructions, 06/2019, C79000-G8976-C512-02
Assignment of the digital inputs/outputs
7 6
PI 7 PI 6
-- --
7 6
DI 7 DI 6
DO 7 DO 6
5 4 3
PI 5 PI 4 PI 3
-- -- --
5 4 3
DI 5 DI 4 DI 3
DO 5 DO 4 DO 3
8
2 1 0
PI 2 PI 1 PI 0
-- -- --
2 1 0
DI 2 DI 1 DI 0
DO 2 DO 1 DO 0
97