Detroit Diesel MBE 900 Operator's Manual page 96

EYE INJURY
To avoid injury from flying debris
when using compressed air, wear
adequate eye protection (face
shield or safety goggles) and do
not exceed 276 kPa (40 psi) air
pressure.
[c] Apply no more than
140 kPa (20 psi) air pressure
intermittently to help dislodge
sediment buildup in the core.
Description
Engine Coolant Capacity (all vehicles) L (Qt.)
Engine capacity
Business Class Coolant System Capacity L (Qt.)
Total capacity
Antifreeze quantity at 50%
Antifreeze quantity at 55%
Table 11 Coolant System Capacity
8. Start the engine and run it for
about one minute at varying
speeds to release air pockets in
the cooling system. Make sure
the heater valve is still open.
Check the coolant level and add
more coolant if necessary.
9. Shut down the engine.
10. Add coolant if necessary.
All information subject to change without notice. (Rev. 04/08)
DDC-SVC-MAN-0040 0704 Copyright © 2008 DETROIT DIESEL CORPORATION
MBE 900 ENGINE 2007 OPERATOR'S GUIDE
5. Drain the radiator, and flush the
radiator until clean water flows
from the radiator. Remove the
flushing gun.
6. When the coolant has drained,
install the coolant drain plug on
the radiator.
7. Add coolant in the specified
concentration until the maximum
mark on the surge tank is reached.
Coolant system capacity is
listed in Table 11.
Value: L (qt.)
11.8 (12.5)
13.1 (13.8)
12 (12.7)
23.6 (25)
85