Shutting Down The Engine; Shutting Down After High Load Operation; Emergency Running Mode - Detroit Diesel MBE 900 Operator's Manual

2. To increase the idle speed, push
the "Resume" switch until the idle
is fast enough.
3. To decrease the idle speed, push
the "Decel" switch until the idle
is slow enough.

Shutting Down the Engine

If the engine has been running at full
output or the coolant temperature has
been high, allow the engine to idle
for one to two minutes without load.
Then turn off the ignition key switch.
If any the following occur, shut down
the engine immediately.
□ The oil pressure swings back and
forth or falls sharply.
□ Engine power and rpm fall, even
though the accelerator pedal
remains steady.
□ The exhaust pipe gives off heavy
smoke.
□ The coolant and/or oil temperature
climb abnormally.
□ Abnormal sounds suddenly occur
in the engine or turbocharger.
All information subject to change without notice. (Rev. 04/08)
DDC-SVC-MAN-0040 0704 Copyright © 2008 DETROIT DIESEL CORPORATION
MBE 900 ENGINE 2007 OPERATOR'S GUIDE
Shutting Down After High Load
Operation
After hard operation, if the engine
has been running at full output or the
coolant temperature has been high,
allow the engine to idle for one to
two minutes without load. Shutting
down the engine without idling may
cause damage to the turbocharger.
Turn off the ignition switch and shut
down the engine.

Emergency Running Mode

The engine is equipped with the
electronic engine control system,
which monitors the engine as it is
running.
As soon as a fault is detected, it is
evaluated and one of the following
measures is initiated.
To prevent possible serious engine
damage, have any faults corrected
without delay by an authorized
dealer.
□ In conjunction with any dash
board or instrument panel display,
the code for the electronic unit
reporting the fault can be read
immediately on the display.
NOTICE:
NOTICE:
37