Midi Program (Midiprog); Status; Output Assignment (Out) - Kurzweil K2661 Musician's Manual

Setup Mode and the Setup Editor
The Channel/Program (CH/PROG) Page

MIDI Program (MIDIProg)

MIDI Program defines which program number is transmitted out the MIDI Out port on the
current zone's MIDI channel.
When you change the value of the LocalPrg parameter, the value of MIDIProg automatically
changes correspondingly. If you want to transmit a MIDI program change number different
from the one corresponding to the local program, select the local program first, then change the
MIDI program.

Status

This parameter determines what the current zone does when you select the setup in Setup
mode. If the value is Active, the zone sends and receives normally via MIDI. Muted means that
the zone sends and receives program changes and entry/exit controller values, but doesn't play
notes. Soloed causes only the current zone to play, "backgrounding" all other zones
(backgrounded zones send and receive program changes and entry/exit controller values, but
don't play notes). With a value of Solo/M, the current zone is both soloed and muted; when the
zone isn't soloed, it won't produce sound).
See the section about zone-status LEDs (page 7-4) for more information about muting and
soloing zones.
For setups containing four or more zones, pressing Mute 1 mutes the current zone; the zone
becomes unmuted when you mute another zone. Pressing Mute 2 or Mute 3 solos the current
zone. You can then press the Chan/Bank buttons to solo each zone.

Output Assignment (Out)

This determines the signal routing for each zone in the setup—not the final audio output, but
the KDFX input to which the zone's signal gets sent. You can route the zone to KDFX A
through D, or you can use a value of Prog, which uses the output assignments of the program
that's assigned to that zone.
7-8