Effects Bus Editor - Kurzweil K2661 Musician's Manual

Effects Bus Editor

The FXBus Editor lets you create effects Preset chains on any of the four stereo effects buses. See
page 9-15 for more information about chaining effects.
Figure 9-2
Figure 9-3
The Add and Remove buttons allow you to define your own chains of effects using up to four
FX Presets. The Add button creates an effects block (shown as a box) to the right of the current
cursor position in the effects chain. You can use a total of four effects in any studio, so if you
create a four-block effects chain on a bus then you won't be able to use any effects on the other
buses in that studio. Your K2661 keeps track of effects usage for you, and won't let you add an
effects block to a bus if you're already max'ed out.
The Remove button deletes the effects block that the FXBUS editor cursor is on. Adding and
deleting effects blocks may cause audio glitches in any signal path and should not be done
during critical listening.
Each FX Preset in an effect chain has two "override" parameters (BusMods) that are displayed
when that FX block is selected. By selecting the name of an override parameter (e.g., Wet/Dry),
you can scroll to choose from any other available parameter.
Each effect also has its full complement of real time modulators as defined and displayed in the
Program and Setup editors.
qWWWWT
!k ©!!!!!!!!!!!!!!!!!!!!!!!!!!!h
CVVVVB
Effects Bus Editor display -- single effect
qWWWWT qwwwwt
!k ©!!!k
CVVVVB CVVVVB
Effects Bus Editor display -- four chained effects
qwwwwt qwwwwt
g!!!k g!!!k
CVVVVB CVVVVB
Basic Effects Mode
Effects Bus Editor
g!h
9-7