Guide Pin
Figure 10-14. Assembling Balance Weight to
Crankshaft (Guide Shoe Design).
Engines Serial No. 3618005223 and Above:
c. Align the weights and insert the balance
weight screw, through the mounting holes
guide pin outside the weight on the PTO side.
Hold the guide pin with a wrench or Torx bit,
and torque the screw to 11.3 N·m (100 in. lb.).
each hole in control link and install one end
over the guide pin.
Figure 10-15. Assembling Balance Weight to
Crankshaft (Control Link Design).
PTO Side
Crank Gear Key
Figure 10-16. Installing Crank Gear Key.
Engines Serial No. 3618005213 and below:
through the PTO seal, and seat fully into place.
connecting rod is away from the cylinder. See
Figure 10-17. Installing Crankshaft Assembly
(Before Serial No. 3618005213).
4. Install the balance weight guide shoe onto
the guide pin with the solid end toward the
Section 10
Reassembly
10
10.5