Disassemble Closure Plate; Remove Cam Gears, Cam Shafts, And Oil Pump; Closure Plate And Gasket Removed From Crankcase; Removing Governor Gear - Kohler Courage SV470 Service Manual

Section 8
Disassembly
3. Remove the closure plate assembly and gasket.
4. If the wiring harness needs to be separated from
the closure plate, pry open the clamps and pull
out through the slot.
Figure 8-37. Closure Plate and Gasket Removed
from Crankcase.

Disassemble Closure Plate

1. Remove the governor gear and regulating pin
assembly. Gently pry upward using the blades of
small molded tabs in the gear. When the
gear is removed these tabs are destroyed
and the gear must be replaced. Governor
gear removal is required for closure plate
disassembly and cleaning of the oil passages.
Figure 8-38. Removing Governor Gear.
8.10
2. Remove the six screws securing the oil passage
cover to the closure plate. Remove the cover and
Figure 8-39. Removing Oil Passage Cover and
Gasket.
Remove Cam Gears, Cam Shafts, and Oil
Pump
1. Remove the thrust washer(s) and cam gears from
38.
NOTE: The ACR weight and spring normally
Thrust Washer
(Intake Side) Early
Models Only
Figure 8-40. Removing Cam Gears.
captured by the thrust washer and
installation of closure plate, will fall out if the
exhaust cam gear is turned upside down.