Typical Reassembly Sequence; Install Pto Side Oil Seal; Section 10. Reassembly - Kohler Courage SV470 Service Manual

The following sequence is suggested for complete
engine reassembly. This procedure assumes that all
components are new or have been reconditioned, and
all component subassembly work has been completed.
This procedure may be varied to accommodate
options or special equipment.
NOTE: Make sure the engine is assembled using
sequences, and clearances. Failure to observe
or damage.
NOTE: Always use new gaskets.
NOTE: Make sure all components have been
properly cleaned BEFORE reassembly.
NOTE: Apply a small amount of oil to the threads
of critical fasteners before assembly, unless a

Typical Reassembly Sequence

The following sequence is suggested for complete
engine reassembly. This procedure assumes that all
components are new or have been reconditioned, and
all component subassembly work has been completed.
The sequence may vary to accommodate options or
special equipment. Detailed procedures follow:

1. Install PTO side oil seal.

5. Install piston rings.
6. Install piston to connecting rod.
8. Install cam levers.
10. Install intake cam gear.
12. Install closure plate gasket, closure plate and
wiring harness.
Section 10
Reassembly
13. Assemble cylinder head.
14. Install cylinder head.
15. Install rocker arms and push rods.
16. Install valve cover.
17. Install stator and wiring harness.
19. Install electric starter.
20. Install ignition module.
21. Install spark plug.
cleaner base.
23. Install and adjust governor lever, mounting speed
control bracket.
27. Install Oil Sentry
28. Install air cleaner element, precleaner and air
cleaner cover.
Install PTO Side Oil Seal
1. Use a seal driver and install to a depth of 5.5 mm
(0.216 in.)
Figure 10-1. Installing PTO Side Oil Seal.
Section 10
Reassembly
™
switch or pipe plug.
10
10.1