3. Use an outside micrometer again and measure
the O.D. of the balance weight guide pin. See
Figure 9-8.
Figure 9-8. Measuring Guide Pin O.D.
4. Use a split ball gauge or dial calipers and
measure the I.D. of the corresponding hole in
the guide shoe. See Figure 9-9. Record these
dimensions.
Figure 9-9. Measuring Guide Shoe Hole I.D.
If any of the measurements taken are outside the
component(s) must be replaced.
Inspection and Reconditioning
Flywheel
Inspection
Inspect the ring gear for cracks or damage. Ring gears
ring gear is damaged.
Section 9
9
9.5