Projecting; Selecting The Image; How To Adjust The State Of The Image - Panasonic PT-VW435NE Operating Instructions Manual

Projecting

Check the connections of the peripheral devices and
connection of the power cord (
on the power ( Æ page 32) to start the projector. Select
the image and adjust the state of the image.

Selecting the image

Select an input signal.
The image selected with the <COMPUTER 1>,
<COMPUTER 2>, <VIDEO>, <S-VIDEO>, <HDMI> or
<NETWORK> button is projected (
Attention
Images may not be projected properly depending on the
z
connected device and DVD, video tape, etc. to be played.
Select a system format that is suitable for the input signal
in [Component] or [RGB] in the [Input] menu (
Check the aspect ratio of the screen and the image and
z
select the optimum aspect ratio under the [Screen] menu
( Æ page 52).
How to adjust the state of the
image
1 ) Adjust the projection angle.
Place the projector parallel to the screen, and
z
then install it on a flat surface so that the screen
becomes rectangle.
If the screen is tilted lower than the screen,
z
extend the adjustable feet to make a rectangle
screen.
For details, see "Adjusting front adjustable feet"
z
( page 28).
Æ
2 ) Adjust the lens shift.
Adjust the projection position with the vertical
z
lens shift ring.
For details, see "Adjusting the position using
z
the vertical lens shift function" (
Æ
page 30) and switch
Æ
page 38).
Æ
page 43).
page 28).
Æ
3 ) Adjust the zoom and the focus.
Turn [Zoom lever] and [Focus lever] to adjust the
image.
Focus lever
Note
It is recommended that the images are projected
z
continuously for at least 30 minutes before the focus is
adjusted.
If you adjust the focus, you may need to adjust the size
z
of the image by moving the zoom lever again.
If keystone distortion occurs, see "KEYSTONE"
z
Æ
( page 53).
Zoom lever
35
ENGLISH -