.
Figure 2–5: Sliding the SAN Switch 2/32 in an HP 9000 Series rack
4. To verify proper alignment, slide the switch in and out of the rack.
Securing the Rack Mount Brackets
Secure the Rack Mount Brackets (installed earlier, see "Attaching the Rear or Front
Mount Brackets") to the rack rails, as follows.
1. Locate two Phillips head 10-32 x 3/8" screws in the Rack Mount Kit accessory
pouch.
2. Secure each rack mount bracket to the rack rails. Tighten the screws, and torque to
25 inch-pounds.
SAN switch 2/32 version 4.0.x installation guide
Installing the SAN Switch 2/32
SHR-2577A
2–15
2–15