Table 2–1: Shipping Carton Contents
Number
1
2
3
SAN switch 2/32 version 4.0.x installation guide
One hp StorageWorks SAN Switch 2/32 product
accessories box containing:
•
One RS-232 Serial cable (convertible to an RJ-45
connector, by removing the adapter on the end of
the cable.)
•
Rack Mount hardware pouch:
•
Power cord clips (6)
•
3-hole bar nuts (4)
•
10-32 x 3/8" Black Phillips head screws (12)
•
8-32 x 3/16" Phillips head screws (10)
•
Square alignment washers (8)
•
Right and left rear rack mount brackets (2), use
if installing so that port side slides from the rear
of the rack
•
Right and left front mount brackets (2), use if
installing so that power supply end slides out
from the front of the rack.
•
Documentation, Release Notes, license, warranty,
and CD
•
Two country specific AC power cords
•
Two Power Distribution Unit (PDU) power cords
(not shown in Figure 2–1)
•
Four rubber mounting feet for standalone
installations on a table or lab bench
Slide assembly, includes one inner and one outer slide
rail, with the following items preinstalled:
•
L-bracket, slide mount, 3-hole (4)
•
Nut, Hex, Locking, 8-32 (4 nuts in each slide
assembly, for a total of 8
•
8-32 x 3/8 inch, zinc slotted screw (requiring a
torque of 15 inch-pounds) (8)
hp StorageWorks SAN Switch 2/32
Installing the SAN Switch 2/32
Item
2–3
2–3