Attaching The Outer Slide Rails To The Hp 9000 Series Rack - HP StorageWorks SAN Switch 2/32 Installation Manual

7. Secure each L-bracket and 3-hole bar nut to the rack's rails with two Phillips head
10-32 x 3/8 in screws (and attached square alignment washers), see Figure 2–4.
.
1
1
Phillips head 10-32 x 3/8 in screw
2
3-hole bar nut
3
Outer slide rail
Figure 2–4: Attaching the outer slide rails to the HP 9000 Series rack
NOTE: Remember to position the 3-hole bar nut behind the L-bracket.
8. Tighten the screws, and torque to 25 inch-pounds.
9. Repeat steps 5 through 7 to secure the other end of the outer slide rail.
10. Repeat steps 3 through 7 to install the second outer slide rail.
SAN switch 2/32 version 4.0.x installation guide
[1] Select this graphic frame.
[2] Select File.
[3] Select Import.
[4] Select File.
3
[5] Choose the appropriate graphic file name.
[6] Make sure you've checked the Copy Into Document.
[7] Select Import. Position the illustration as required.
[8] Adjust the size of the outer graphic frame as required.
2
Delete this set of instructions
Installing the SAN Switch 2/32
4
5
4
L-Brackets
5
Power cord clip (1 of 6)
SHR-2478A
2–13 2–13