Installing The Mounting Brackets - HP StorageWorks SAN Switch 2/32 Installation Manual

IMPORTANT: For proper airflow, the SFP media side of the SAN Switch 2/32 faces the rear of
the rack. This mounting allows air to enter from the front of the rack and to exhaust at the rear of
the rack, similar to other rack-mounted equipment. This prevents switch overheating, which may
cause it to fail.
Use these steps to install the switch in the HP System/e rack.
1. Verify that all required hardware is available.
2. Choose a mounting location in the rack for the switch.
3. Install each of the two mounting brackets with (1) M5 Torx head screw with
captive lock washers as shown in Figure 2–6.
Figure 2–6: Installing the mounting brackets
SAN switch 2/32 version 4.0.x installation guide
Installing the SAN Switch 2/32
SHR-2581A
2–17 2–17