Intermec EasyCoder 501XP Programmer's Reference Manual page 34

Chapter 4 — Label Design
Enabling/Disabling Partial Fields
Normally, any fi eld that extends outside the print window, as specifi ed
by the printer's setup in regard of media size (X-start, width, and length),
will cause Error 1003 "Field out of label." This can easily happen while
you design your label layout, for example when changing the font,
font size, direction, alignment, etc. Even "invisible" parts of a fi eld, for
example "transparent" parts of an image may cause such errors.
If your label layout contains many fi elds, it may be diffi cult to grasp
all implications of a change. However, it is possible to enable so called
"partial fi elds."
CLIP ON/CLIP OFF
line, and box fi elds. For partial bar code fi elds, a more complex syntax is
required.
When partial fi elds are enabled, a fi eld that extends outside the print
window will not cause Error 1003, but will be clipped at the edge of the
window and not included in the printout. Thus, you can print a sample
and more easily determine what is wrong.
CLIP [BARCODE [HEIGHT|INFORMATION|X|Y]] [ON|OFF]
BARCODE
HEIGHT
INFORMATION
X
Y
Default: CLIP OFF
Example:
Only the last part of the text fi eld will be printed, since the fi eld is right-
aligned and the insertion point is close to the left-hand edge of the print
window.
CLIP ON ↵
PP 350,100 ↵
AN 6 ↵
PT "INTERMEC PRINTERS" ↵
PF ↵
XOR Mode
The instruction
XORMODE
At
XORMODE OFF
, the intersection will be white.
ON
28 Intermec Direct Protocol v7.80 Programmer's Reference Manual
Toggles between partial bar code enable/disable.
clips the height of the bars.
clips the bar code lengthwise.
clips the part of the bar code that comes outside the print window in the
X-dimension.
clips the part of the bar code that comes outside the print window in the
Y-dimension.
controls how intersecting fi elds will be printed.
(default), the intersection will be black, and at
is suffi cient for partial text, image,
XORMODE