Intermec EasyCoder 501XP Programmer's Reference Manual page 127

Code Message/Explanation
1008 Lss too low.
1009 Invalid parameter.
1010 Hardware error.
1011 I/O error.
1012 Too many fi les opened.
1013 Device not found.
1014 File not found.
1015 File is read-only.
1016 Illegal argument.
1017 Result too large.
1018 Bad fi le descriptor.
1019 Invalid font.
1020 Invalid image.
1021 Too large argument for MAG.
1022 Head lifted.
1023 Incomplete label.
1024 File too large.
1025 File does not exist.
1026 Label pending.
1027 Out of transfer ribbon.
1028 Media type is not selected.
1029 Printhead voltage too high.
1030 Character is missing in chosen font.
1031 Next label not found.
1032 File name too long.
1033 Too many fi les are open.
1034 Not a directory.
1035 File pointer is not inside the fi le.
1036 Subscript out of range.
1037 No acknowledge received within specifi ed
timeout.
1038 Communication checksum error.
1039 Not mounted.
1040 Unknown fi le operating system.
1041 Error in fos structure.
1042 Internal error in mcs.
1043 Timer table full.
1044 Low battery in memory card.
1045 Media was removed.
1046 Memory checksum error.
1047 Interrupted system call.
1051 Dot resistance measure out of limits.
1052 Error in printhead.
1053 Unable to complete a dot measurement.
Intermec Direct Protocol v7.80 Programmer's Reference Manual
Chapter 11 — Error Messages
Code Message/Explanation
1054 Error when trying to write to device.
1055 Error when trying to read from device.
1056 O_BIT open error.
1057 File exists.
1058 Transfer ribbon fi tted.
1059 Cutter does not respond.
1060 DC motor to ribbon save did not start/stop.
1061 Wrong type of media.
1062 Not Allowed.
1081 Timer expired.
1082 Unsupported protocol.
1083 Ribbon Low
1101 Illegal character in bar code.
1102 Illegal bar code font.
1103 Too many characters in bar code.
1104 Bar code too large.
1105 Bar code parameter error.
1106 Wrong number of characters.
1107 Illegal bar code size.
1108 Number or rows out of range.
1109 Number of columns out of range.
1201 Insuffi cient font data loaded.
1202 Transformation matrix out of range.
1203 Font format error.
1204 Specifi cations not compatible with output
module.
1205 Intelligent transform not supported.
1206 Unsupported output mode requested.
1207 Extended font not supported.
1208 Font specifi cations not set.
1209 Track kerning data not available.
1210 Pair kerning data not available.
1211 Other Speedo error.
1212 No bitmap or outline device.
1213 Speedo error six.
1214 Squeeze or clip not supported.
1215 Character data not available.
1216 Unknown font.
1217 Font format is not supported.
1218 Correct mapping table is not found.
1219 Font is in the wrong direction.
1220 Error in external map table.
1221 Map table was not found.
1222 Double byte map table is missing.
121