Installation - Cisco Catalyst 2955 Hardware Installation Manual

Installation

This chapter describes how to install your switch, interpret the power-on self-test
(POST), and connect the switch to other devices.
If your installation is in a hazardous environment, see
Note
a Hazardous Environment,"
Read these topics, and perform the procedures in this order:
•
•
•
•
•
•
•
•
•
•
•
•
78-14944-03
Preparing for Installation, page 3-2
Applying the Switch Protective Liner, page 3-10
Verifying Switch Operation, page 3-11
Connecting the Switch to the Power Converter, page 3-29
Wiring the External Alarm Device Relays, page 3-48
Installing the Switch on a DIN Rail, page 3-52
Installing the Switch in a Rack, page 3-57
Removing the Switch from a DIN Rail or a Rack, page 3-59
Connecting to 10/100 and 10/100/1000 Ports, page 3-62
Connecting to 100BASE-FX MM Ports, page 3-65
Connecting to 100BASE-LX SM Ports, page 3-67
Where to Go Next, page 3-69
C H A P T E R
for instructions.
Catalyst 2955 Hardware Installation Guide
3
Chapter 4, "Installation in
3-1