Cisco Catalyst 2955 Hardware Installation Manual page 120

Installing the Switch on a DIN Rail
Figure 3-29
1
2
Rotate the switch down toward the DIN rail until the release tab on the rear panel
Step 2
clicks.
Lift lightly on the bottom of the switch to ensure that it is firmly locked in place.
Step 3
After the switch is mounted on the DIN rail, power on the switch as described in
"Powering On the Switch and Running POST" section on page
Catalyst 2955 Hardware Installation Guide
3-56
Mounting the Switch on a DIN Rail in a Face-Down Position
3
DIN rail clip DIN rail clip release tab
DIN rail
Chapter 3 Installation
1
2
3
3-13.
78-14944-03