Setting The Number Of Copies; Reduction/Enlargement/Zoom; Automatic Ratio Selection - Sharp AR-7024 Operation Manual

COPY FUNCTIONS

SETTING THE NUMBER OF COPIES

Press the numeric keys to set the number of copies.
The set number of copies appears in the Number of
copies display. A maximum of 999 copies (factory
default setting) can be set.
If you wish to make only a single copy, copying is
possible with the display showing "0".
If you enter the wrong number, press the
Note
[CLEAR] key (
number.

REDUCTION/ENLARGEMENT/ZOOM

The zoom function enables precise copy ratio selection from 25% to 400% in increments of 1%.
There are three ways to enlarge and reduce copies, as explained below.
• Reduction and enlargement ratios can be selected automatically.

"AUTOMATIC RATIO SELECTION"

• Reduction and enlargement ratios can be selected manually.
"MANUAL RATIO SELECTION" (p.49)
• Separate settings can be selected for the vertical and horizontal ratios.
"SELECTING THE VERTICAL AND HORIZONTAL COPY RATIOS SEPARATELY (XY ZOOM Copying)" (p.50)
Ratios that can be selected will vary depending on whether the original is placed on the document glass or in the RSPF.
Original position
Document glass
RSPF
AUTOMATIC RATIO SELECTION
1
Place the original(s) in the document
feeder tray or on the document glass.
2
If the original is placed on the document
glass, select the original size.
• Automatic ratio selection can be used when
Note
the original size is A5, B5, B5R, A4, A4R,
B4, A3, (5-1/2" x 8-1/2", 8-1/2" x 11",
8-1/2" x 11"R, 8-1/2" x 13", 8-1/2" x 14" or
11" x 17"). The sizes of paper that can be
used vary by country and region. It cannot
be used for other sizes.
• After placing the original, be sure to close
the document cover/RSPF. If left open,
parts outside of the original will be copied
black, causing excessive use of toner.
48
) and enter the correct
(below)
(p.44)
Important note when making a large number
of copies
When the maximum number of pages (about 250
pages) that can be held in the paper output tray are
output, copying will temporarily stop. When this
happens, promptly remove the copies and press the
[START] key (
also stop after about 500 pages and 750 pages.
Remove the pages and resume copying in the same
way.
The maximum number of copies can be
Note
changed in the system settings.
Selectable ratios
25% – 400%
50% – 200%
3
Use the [TRAY] key to select the paper
tray with the desired paper size.
) to resume copying. Copying will
(p.94)
This feature will not work
when using copy paper
of non-standard size or
when using the bypass
tray.