The Start Indicator Is Not Lit In The Usb Memory Scan Mode; Err" Appears In The Display During Scan To Desktop Mode; Err" Appears In The Display During Usb Memory Scan; Err" Appears During Scan To Sharpdesk Mobile - Sharp AR-7024 Operation Manual

TROUBLESHOOTING
Problem
The START indicator is
not lit in the USB
Memory Scan mode.
"ERR" appears in the
display during Scan to
Desktop mode.
"ERR" appears in the
display during USB
Memory Scan.
"ERR" appears during
Scan to Sharpdesk
Mobile.
"FUL" appears in the
display during USB
Memory Scan.
112
The USB memory is not recognized or not inserted, or any device
other than USB memory is inserted in the USB port.
 Check the USB port of the Network expansion kit.
In the case of executing Scan to Desktop, an error will occur on the
machine if the network scanner tool profile is deleted before Scan to
Desktop is used.
 If scanning is executed using Sharpdesk Mobile on the mobile device after a
network scanner tool profile is registered, the network scanner tool profile
will be deleted. If you need to use Scan to Desktop, re-register the network
scanner tool profile.
Any device other than USB memory is inserted in the USB port, the
USB memory is write-protected, or it was taken off during USB
Memory Scan.
 Check your USB memory device and use it properly.
You have not registered the machine on Sharpdesk Mobile in the
mobile devices.
 Register the machine on Sharpdesk Mobile.
The memory of the USB device became full.
 Use the USB device with sufficient memory.
Cause and solution Page
–
83
–
83
–