Sharp AR-7024 Operation Manual page 95

Program
Program name
number
Use close
30
paper size
Default tray
31
setting
Default
32
exposure mode
USB 2.0 mode
33
switching
Sort auto
34
*1
select
35 ID card
Auto power
shut-off
switching
36
immediately
after print job
finishes
IP ADDRESS
37
*3
SETTING
Status display
38 pattern
switching
The number of
39 ID Card copy
setting
The memory
method of
40 paper type on
bypass tray
settings
1
* When the RSPF is installed.
2
* When the 500-sheet paper feed units are installed.
3
* When the network expansion kit is installed.
4
* When pressed [CLEAR ALL] key(
off, the paper type on bypass tray will resume to plain paper.
Setting codes
(factory default setting
appears in bold)
0: OFF
1: ON
1: Tray1
*2
2: Tray2
*2
3: Tray3
*2
4: Tray4
5: Bypass tray
1: AUTO
2: TEXT
3: PHOTO
1: Full-Speed
2: Hi-Speed
1: OFF
2: Sort
3: Group
1: Pattern 1
2: Pattern 2
0: OFF
1: ON
ENABLE DHCP
- YES
- NO
IP ADDRESS
SETTING
-IP ADDRESS
-SUBNET MASK
-DEFAULT GATEWAY
1: Pattern 1
2: Pattern 2
1: Single
2: Multi
0: Memory
*4
1: No memory
), exceeding the auto clear time, resumed auto-power shut-off mode , or power on and
Explanation
• When this function is enabled, printing in printer
mode will automatically continue using a different size
of paper if the specified size of paper runs out in all
trays. This feature does not function in copy mode.
• Use this program to select a default tray. This tray is
automatically selected each time the power is turned
on or each time the machine reverts to the initial
settings.
• Use this program to set "AUTO", "TEXT", or "PHOTO"
as the default exposure mode.
• This sets the USB 2.0 data transfer speed. If your
computer is not compatible with USB 2.0 (Hi-Speed),
use this program to change the USB 2.0 mode to
"Full-Speed".
• Use this setting to select the default output mode for
copying from the RSPF.
• Use this setting to copy the front and back sides of ID
card onto a page, and to use margin shift feature.
• This function automatically switches the machine to
auto power shut-off mode immediately after a print
job finishes.
If "OFF" is set, the duration of time for the Auto power
shut-off timer set in the program number (3) is
enabled.
• If "YES" is selected (factory default setting) and the
machine is connected to a TCP/IP network, the IP
address will be acquired automatically. This is the
factory default setting.
If you will manually assign an IP address, select "NO".
For the detailed procedure, see
"ENABLING/DISABLING DHCP"
• This program is used to set the IP address (IP
address, Subnet Mask, and Gateway) of the machine
when TCP/IP protocol is used on the network.
For the detailed procedure, see
ADDRESS" (p.98).
• This sets the display pattern of the data notification
indicator ( ).
• This function is used to set the number of copies
when copying ID card.
• This function is used to set the paper type on bypass
tray.
USER SETTINGS
6
(p.97).
"SETTING THE IP
95