Copy Functions; Normal Copying - Sharp AR-7024 Operation Manual

Chapter 3
3

COPY FUNCTIONS

This chapter explains how to use the copy functions.

NORMAL COPYING

This section explains how to make a regular copy.
If "Auditing mode" has been enabled (p.99), enter your 3-digit account number.
Copying from the document glass
1
Open the document cover/RSPF, and
place the original.
An original up to A3 (11" x 17") can be placed
Note
on the document glass.
2
Close the document cover/RSPF.
3
Press the [ORIGINAL] key.
44
Place the original face
down on the document
glass.
[
After placing the original,
be sure to close the
document cover/RSPF.
If left open, parts outside
of the original will be
copied black, causing
excessive use of toner.
4
Specify the size of the original with
the [SIZE] key.
Make sure that the TRAY indicator lights up.
If the indicator is not lit, no tray has the same size of
paper as the original. Load paper of the required size
in a tray, or select the bypass tray with the [TRAY] key
and copy from the bypass tray.
The bypass tray must be manually selected.
To copy on paper of a different size than the original,
select the paper with the [PAPER] key and [SIZE] key.
When you have finished setting the original size, press
the [START] ( ) key.
5
Set the number of copies.
6
Press the [START] key (
copying.
• The paper output tray can hold up to 250
Note
sheets of paper.
• About one minute after copying ends, "Auto
clear" activates and restores the copy
settings to the initial settings.
setting for "Auto clear time" can be changed
in the system settings.
• Press the [CLEAR] key (
in the middle of a run.
When the original size is
selected, the tray with the
same size of paper is
automatically selected.
(When there are two or
more paper trays)
) to begin
The copy is delivered to
the paper output tray.
(p.37) The
(p.93)
) to stop copying