Removing The 4-Cell Battery - Dell Latitude 5430 Service Handbook

About this task
The following image indicates the location of the 3-cell battery and provides a visual representation of the installation procedure.
NOTE: If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
Steps
1. Align and place the battery from the left side on the computer.
2. Replace the three (M2x5) screws to secure the battery to the palm-rest assembly.
3. Connect the battery cable to the connector on the system board.
Next steps
1. Install the base cover.
2. Install the microSIM card.
3. Install the microSD card.
4. Follow the procedure in

Removing the 4-cell battery

Prerequisites
1. Follow the procedure in
2. Remove the microSD
3. Remove the microSIM
4. Remove the base cover.
NOTE: If battery is disconnected from system board for service, then there is a delay during system boot-up as the system
undergoes RTC battery reset.
About this task
The following images indicate the location of the battery and provide a visual representation of the removal procedure.
after working inside your
before working inside your
card.
card.
computer.
computer.
Ta bort och installera komponenter 31