Dell Latitude 5430 Service Handbook page 62

Steps
1. Place the display assembly on the computer. Align the screw holes on the display hinges with screw holes on the palm-rest
assembly.
2. Replace the four (M2.5x5) screws to secure the display hinges to the palm-rest assembly.
3. Close the display.
4. Route the antenna cables through the routing guide and adhere the tape to secure the cables to the system board.
5. Route the display and eDP cable through the routing guide on the system board.
6. Connect the eDP cable to the connector on the system board.
7. Connect the display cable to the connector on the system board.
8. Adhere the tape that secures the display cable to the system board.
9. Align the screw holes on the eDP cable bracket with the screw holes on the system board.
10. Replace the two (M2x3) screws that secure the eDP cable bracket to the system board.
62 Ta bort och installera komponenter